LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Differential Carrier Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Drive Carrier & Differential Carrier
    GM15506Courtesy of GENERAL MOTORS CORP.
  1. Locate the dowels on the final drive carrier (100) and insert these dowels into the holes in the differential carrier (110) for proper assembly.
    2. NOTE: Refer to Fastener Notice .
  2. Install the differential carrier bolts (119).

    Tighten:  Tighten the bolts using a star pattern to 70-76 N.m (52-56 lb ft).

  3. Install the case extension. Refer to Case Extension Replacement .
scientia non olet · About LEMON Manuals