LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Automatic Transmission Fluid Pressure Test Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Oil Pressure Test Plug
    GM784411Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the oil pressure test plug (1).

    Tighten:  Tighten the oil pressure test plug to 22 N.m (16 lb ft).

  2. Install the throttle body air inlet duct.