Vehicle Speed Sensor and Transmission Fluid Cooler Pipe Fitting Removal

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Output Shaft Speed Sensor And Seal

Courtesy of GENERAL MOTORS CORP.

Remove the 10 mm bolt (131) from the output shaft speed sensor.
Remove the output shaft speed sensor and seal (130).

Fig 2: Cooler Line Fitting & Seal

Courtesy of GENERAL MOTORS CORP.

Remove the 19 mm cooler line fitting (3) and seal (4).