Vehicle Speed Sensor and Transmission Fluid Cooler Pipe Fitting Installation

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Output Speed Sensor (OSS)

Courtesy of GENERAL MOTORS CORP.

Inspect the output speed sensor (130) for damage or a cut seal (4).
Inspect the cooler connector (3) for damaged threads, clogging, or a cut seal (4).

Fig 2: Output Speed Sensor & Seal

Courtesy of GENERAL MOTORS CORP.

Install the output speed sensor (130) and the seal (4).

NOTE: Refer to Fastener Notice .

Install the output speed sensor bolt (131).
Tighten: Tighten the bolt to 8-14 N.m (6-10 lb ft).
Install the cooler fitting (3) and the new seal (4) or fitting (38) and seal (39) into the case.
Tighten: Tighten the cooler fitting to 25-29 N.m (19-21 lb ft).