Tools Required

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

J 39053 Forward and Coast Clutch Assembly Installer. See Special Tools .

Fig 1: Identifying Forward/Coast Clutch & Support Assembly With J 39053

Courtesy of GENERAL MOTORS CORP.

CAUTION: The forward and coast clutch assembly weighs approximately 50 lbs. Personal injury may result if you drop the assembly.

Install the J 39053 into the forward and coast clutch and support assembly (636-834). See Special Tools .
Using a chain hoist or suitable lifting equipment, install the forward and coast clutch and support assembly (636-834) into the barrel of the case. The two bolt holes and feed holes must line up with the holes in the bottom of the case.