LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Forward Clutch Support Stud Installation

Forward Clutch Support Stud Installation

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rotating Forward & Coast Clutch Support Counterclockwise Against Spline
    GM11927Courtesy of GENERAL MOTORS CORP.
  1. Rotate the forward and coast clutch support (822) counterclockwise against the spline. Do this by tapping on the support in a counterclockwise direction against the splines.
    2. Fig 2: Identifying Forward Clutch Support Studs
    GM11928Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the forward clutch support studs (5). First tighten the stud closest to the bench (or the rear of the vehicle). Then tighten the second stud.

    Tighten:  Tighten the studs to 25-27 N.m (19-20 lb ft).

scientia non olet · About LEMON Manuals