LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Channel Plate Assemble >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Lower Channel Plate Accumulator Bores & Mating Surfaces
    GM12043Courtesy of GENERAL MOTORS CORP.
  1. Inspect the lower channel plate accumulator bores and mating surfaces for scratches or damage.
    2. Fig 2: Inspection Areas On Lower Channel Plate
    GM15457Courtesy of GENERAL MOTORS CORP.
  2. Inspect the bottom side of the lower channel plate for damage to the bolt holes or debris in passages.
    3. Fig 3: Identifying Spacer Plate & Gasket Assembly & Lower Channel Plate With J 39630-1 & J 39630-2
    GM509686Courtesy of GENERAL MOTORS CORP.
  3. Insert the J 39630-1  into the lower channel plate (900) and rest the channel plate on the guide pin heads. See Special Tools .
  4. Install the J 39630-2  into the lower channel plate (900). See Special Tools .
  5. Install the spacer plate and gasket assembly (935) onto the lower channel plate (900).
scientia non olet · About LEMON Manuals