LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Case Cover/Turbine Shaft Seal Replacement >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Case Cover To Turbine Shaft Seal With J 7079-2 & J 39062
    GM11988Courtesy of GENERAL MOTORS CORP.
  1. Using J 7079-2  (1) and the remover side of the J 39062  (2), remove the case cover to turbine shaft seal (35). See Special Tools .
    2. Fig 2: Identifying Case Cover To Drive Sprocket Seal
    GM11989Courtesy of GENERAL MOTORS CORP.
  2. Using a small screwdriver, remove the case cover to drive sprocket seal (34) by tapping the seal out through the slots in the case cover.
    3. Fig 3: Identifying Case Cover To Turbine Shaft Seal With J 7079-2 & J 39062
    GM11991Courtesy of GENERAL MOTORS CORP.
  3. Using J 7079-2  (1) the installer side of the J 39062  (2), install the case cover to turbine shaft seal (35). See Special Tools .
    4. Fig 4: Identifying Case Cover To Drive Sprocket Seal With J 8092 & J 39648
    GM11992Courtesy of GENERAL MOTORS CORP.
  4. Using J 8092  (1) and J 39648  (2), install the case cover to drive sprocket seal (34). See Special Tools .
scientia non olet · About LEMON Manuals