LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> 4th Band and Third Clutch/Reaction Shell Removal

4th Band and Third Clutch/Reaction Shell Removal

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Reverse Clutch Housing & Second Sprag Assembly
    GM11868Courtesy of GENERAL MOTORS CORP.
  1. Remove the reverse clutch housing and the second sprag assembly (500-520). Grasp the second sprag race to remove.
  2. Remove the 4th band (523).
  3. Remove the third clutch and the reaction carrier assemblies. Grasp the input shaft to remove the third clutch and reaction carrier assembly (604, 623).
  4. Remove the reaction carrier shell (633).
scientia non olet · About LEMON Manuals