Tools Required

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.

J 34741-3 Input Shaft Seal Sizer

Fig 1: Identifying Fourth Band

Courtesy of GENERAL MOTORS CORP.

Install the fourth band (523) into the case. Seat the band properly onto the anchor pin with the seat of the servo pin toward the servo bore in the case.

Fig 2: View Of J 34741-3 Over Input Shaft Oil Seal Rings

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Leave the J 34741-3 in place until the reverse clutch and housing assembly is ready to be installed.

Install the J 34741-3 over the input shaft oil seal rings. Use a twisting motion to install the J 34741-3 . The J 34741-3 must contact the third clutch housing hub.