LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Diagnostic Information And Procedures >> Transmission Fluid Cooler Flushing and Flow Test (J 45096) >> Back Flush Procedure

Back Flush Procedure

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying J 45096 Adapters At Oil Cooler Supply & Return Lines
    GM1212336Courtesy of GENERAL MOTORS CORP.
  1. Connect the J 45096  adapters (1) to the vehicle's transmission oil cooler supply and return lines at the transmission.
    2. Fig 2: Identifying Black Supply Hose & Clear Waste Hose
    GM1212338Courtesy of GENERAL MOTORS CORP.
  2. Connect the black supply hose (1) to the return line, rear connector of the transmission, and the clear waste hose (2) to the feed line, front connector of the transmission, to the vehicle cooler lines. This is the reverse flow - backflush direction.
    3. Fig 3: View Of Main Function Switch FLUSH Position
    GM1212339Courtesy of GENERAL MOTORS CORP.
  3. Turn the main function switch to the FLUSH position. Allow the machine to operate for 30 seconds.
    4. Fig 4: View Of Main Function Switch IDLE Position
    GM1212341Courtesy of GENERAL MOTORS CORP.
  4. Turn the main function switch to the IDLE position and allow the supply vessel pressure to dissipate.
scientia non olet · About LEMON Manuals