LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 707 (Automatic Transaxle - 4T80-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Diagnostic Information And Procedures >> Line Pressure Adapter and Gage Installation >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2008 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly.
    2. Fig 1: Identifying Line Pressure Plug
    GM29353Courtesy of GENERAL MOTORS CORP.
  2. Remove the line pressure plug.
    3. Fig 2: View Of J 21867-100 Installed On Transmission
    GM29354Courtesy of GENERAL MOTORS CORP.
  3. Install J 21867-100  using a ratchet box wrench. See Special Tools . Tighten the adapter so that the insert hole for the dowel rod is in a 1 o'clock position.
    4. Fig 3: View Of J 21867-94 & J 21867-100 Installed On Transmission
    GM29355Courtesy of GENERAL MOTORS CORP.
  4. Install the dowel rod from J 21867-94  . See Special Tools .
    5. Fig 4: View Of Line Pressure Gage & Hose On Dowel Rod Fitting
    GM29356Courtesy of GENERAL MOTORS CORP.
  5. Attach a line pressure gage and hose to the dowel rod fitting.
  6. Secure the hose in a safe position to avoid damage to the tools and vehicle during the line pressure testing.
  7. When you have completed the testing procedure, remove the line pressure gage and hose from the dowel rod fitting.
  8. Remove the dowel rod.
  9. Remove J 21867-100  using a ratchet box wrench. See Special Tools .
  10. Install the line pressure plug.
  11. Install the air cleaner assembly.
scientia non olet · About LEMON Manuals