Knee Bolster Replacement

WARNING: This page is about a different car, the 2007 Saturn Sky. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Knee Bolster

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the left instrument panel closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side . Remove the left instrument panel outer trim cover. Refer to Instrument Panel Outer Trim Cover Replacement .
1	Knee Bolster Screw (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2.5 N.m (22 lb in)
2	Knee Bolster Assembly Procedures Disconnect the electrical connections. When replacing the knee bolster assembly, transfer all necessary components.
3	Retainer Clips (Qty: 3)