LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 1 Of 5)) >> On-Vehicle Repair Instructions (Part 1) >> Engine Support Fixture >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the complete engine support fixture assembly.
  2. Remove the power steering reservoir bracket.
  3. Attach the power steering reservoir to bracket and install the screws.

    Tighten:  Tighten the power steering reservoir screws to bracket to 6 N.m (53 lb in).

  4. Install the power steering reservoir and bracket assembly.

    Tighten:  Tighten the power steering reservoir bracket bolts: M6 bolt to 9 N.m (7 lb ft) and M8 bolt to M8 Bolt to 25 N.m (18 lb ft)

  5. Install the engine mount struts. Refer to Engine Mount Strut Replacement - Right  and Engine Mount Strut Replacement - Left .
scientia non olet · About LEMON Manuals