LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 196 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions - 1 Of 5)) >> On-Vehicle Repair Instructions (Part 1) >> Engine Mount Strut Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 Buick LaCrosse and 2006 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the left engine mount strut bracket and bolts to the vehicle.
    2. Fig 1: View Of Engine Mount Strut Bracket Bolts
    GM1457530Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the engine mount strut bracket bolts to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolts to 50 N.m (37 lb ft).

    3. Fig 2: Identifying Exhaust Crossover Pipe Nuts & Studs
    GM1395470Courtesy of GENERAL MOTORS CORP.
  3. Install the exhaust crossover pipe nuts (5) and studs (1).

    Tighten:  Tighten the exhaust crossover pipe nuts (5) to 34 N.m (25 lb ft).

  4. Connect the PCV tube to the air intake duct.
  5. Install the left engine mount strut to the left engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left .
scientia non olet · About LEMON Manuals