LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Engine Mount Strut Bracket Replacement - Right >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  2. Disconnect the pulley from the generator.
  3. Remove the right engine mount strut and radiator support bracket from the right engine mount strut bracket. Refer to Engine Mount Strut Replacement - Right .
  4. Remove the generator bolts from the generator.
  5. Move the generator off to the side to provide access to the engine mount strut bracket bolts.
    6. Fig 1: Locating Engine Mount Strut Bracket Bolts
    GM1457532Courtesy of GENERAL MOTORS CORP.
  6. Remove the engine mount strut bracket bolts from the cylinder head.
  7. Remove the right engine mount strut bracket from the vehicle.
scientia non olet · About LEMON Manuals