LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Malibu Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Engine Mechanical - 3.6L (Ly7) (Repair Instructions -- 1 Of 5)) >> On-Vehicle Repair Instructions - Part 1 >> Camshaft Position (CMP) Actuator Replacement - Bank 2 (Left) Intake >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Buick LaCrosse and 2005 Buick Allure. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Camshaft Position (CMP) Actuator
    GM946219Courtesy of GENERAL MOTORS CORP.
  1. Install the camshaft position actuator to the timing chain.
    2. NOTE: Refer to Torque Reaction Against Timing Drive Chain Notice in Cautions and Notices.
  2. Install the camshaft. Refer to Camshaft Replacement - Left .
scientia non olet · About LEMON Manuals