Installation Procedure

Fig 1: Installing Knee Bolster Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the knee bolster bracket bolts to the instrument carrier in the sequence shown.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 2: IP Driver Knee Bolster To Lower Trim Panel Bracket Bolts

Courtesy of GENERAL MOTORS CORP.

Install the knee bolster bracket bolts which secure the bracket to the IP lower trim panel.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
Install the steering column filler panel. Refer to Steering Column Filler Replacement .
Install the left IP insulator. Refer to Closeout/Insulator Panel Replacement - Left .