Driver Information Center (DIC) Compass Inaccurate or CAL Displayed
Driver Information Center (DIC) Compass Inaccurate or CAL Displayed
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Driver Information System Schematics | |||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Verify that the compass is inaccurate or CAL or C is displayed. Does the system operate normally? |
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 | Turn ON the ignition, with the engine OFF. Is the compass display blank? |
Go to Step 7 | Go to Step 4 |
| 4 | Is CAL displayed? | Go to Step 5 | Go to Step 6 |
| 5 | Perform the compass calibration procedure. Refer to Electronic Compass Calibration . Does the compass operate properly? |
Go to Step 8 | Go to Step 6 |
| 6 | Perform the compass variance procedure. Refer to Electronic Compass Calibration . Does the compass operate properly? |
Go to Step 8 | Go to Step 7 |
| 7 | Replace the driver information center (DIC). Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 8 | - |
| 8 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |