LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement - Output >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    2. IMPORTANT: This procedure is for 2WD vehicles. If the vehicle is equipped with 4WD, the output speed sensor is located on the transfer case.
  2. Disconnect the output speed sensor (2) electrical connector.
  3. Remove the output speed sensor bolt.
  4. Remove the output speed sensor (2) and the bracket assembly from the case.
  5. Inspect the output speed sensor assembly (2) for any evidence of damage.
scientia non olet · About LEMON Manuals