LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement - Output >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Input & Output Speed Sensors
    GM686957Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the output speed sensor seal with automatic transmission fluid.
  2. Install the output speed sensor (2) and the bracket assembly.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the bolt.

    Tighten:  Tighten the bolt to 11 N.m (96 lb in).

  4. Connect the output speed sensor electrical connector.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals