LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Transmission Mount Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transmission Mount & Bolts (4WD)
    GM829712Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission mount to the vehicle.
  2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the transmission mount mounting bolts, for 4WD vehicles.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Fig 2: Transmission Mount & Bolts (RWD)
    GM829713Courtesy of GENERAL MOTORS CORP.
  5. Install the transmission mount mounting bolts, for RWD vehicles.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the transmission support. Refer to Transmission Support Replacement in Frame and Underbody.
  7. Remove the transmission jack.
  8. Lower the vehicle.