LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Transmission Fluid Auxiliary Cooler Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Auxiliary Cooler & Mounting Bracket
    GM765118Courtesy of GENERAL MOTORS CORP.
  1. Install the oil cooler into the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the upper bolts into the oil cooler bracket.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  4. Install the lower bolts to the oil cooler bracket.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Lower the vehicle.
    6. Fig 2: Oil Cooler Lines At Auxiliary Oil Cooler
    GM765119Courtesy of GENERAL MOTORS CORP.
  6. Connect the oil cooler lines to the auxiliary oil cooler.
  7. Attach the oil cooler lines to the push clips in the mounting bracket.
  8. Reinstall the grille assembly. Refer to Grille Replacement (Uplevel) or Grille Replacement (Base) .
scientia non olet · About LEMON Manuals