Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install a new case extension O ring seal (2).
- Install the case extension (1).NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the case extension bolts (3).
Tighten: Tighten the case extension bolts (3) to 34 N.m (25 lb ft).
- Install the transmission support and the transmission mount. Refer to Transmission Mount Replacement .
- Install the propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece in Propeller Shaft.
- Remove the drain pan and the transmission jack.
- Lower the vehicle.
- Fill the transmission to the proper level with Dexron® III transmission fluid. Refer to Transmission Fluid Checking Procedure .