Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the rear servo assembly to the transmission case as follows:
- Accumulator spring (14)
- Selective pin (13)
- Servo spring retainer (12)
- Servo spring (11)
- Washer (10)
- Piston seal (9)
- Accumulator piston (8)
- Inner ring oil seal (7)
- Outer ring oil seal (1)
- Servo piston (2)
- Bottom retaining clip (3)
- Cover gasket (4)
- Cover (5)
- Cover Bolt (6)
- Install the cover bolts (61).
Tighten: Tighten the bolts to 24 N.m (18 lb ft).
- Install the transmission oil pan and filter. Refer to Automatic Transmission Fluid/Filter Replacement .
- Lower the vehicle.
- Fill the transmission to the proper level with Dexron® III transmission fluid. Refer to Transmission Fluid Checking Procedure .
NOTE:
Refer to Fastener Notice in Cautions and Notices.