LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Automatic Transmission Range Selector Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Shift Cable-To-Steering Column Bracket Retaining Clip
    GM765121Courtesy of GENERAL MOTORS CORP.
  1. Apply the parking brake.
  2. Position the steering column shift lever to park.
  3. Remove the knee bolster trim panel. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages and Console.
  4. Remove the knee bolster bracket. Refer to Knee Bolster Bracket Replacement - Left in Instrument Panel, Gages and Console.
  5. Remove the clip securing the shift cable to the steering column bracket.
  6. Remove the shift cable from the steering column shift control.
  7. Remove the rubber grommet from the floor panel.
  8. Remove the air cleaner assembly.
    9. Fig 2: Left Front & Rear Shift Cable Clips
    GM105217Courtesy of GENERAL MOTORS CORP.
  9. Remove the shift cable clips from the left front of the engine compartment.
  10. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  11. Remove the shift cable clips from the left rear engine bracket.
    12. Fig 3: Shift Cable Removed
    GM765122Courtesy of GENERAL MOTORS CORP.
  12. Remove the shift cable from the stud ball.
  13. Remove the locking clip from the cable at the bracket.
  14. Lower the vehicle.
  15. Remove the shift cable from the vehicle.
scientia non olet · About LEMON Manuals