LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Automatic Transmission Range Selector Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: Prior to installing the shift cable to the vehicle, ensure that the column shift lever and the transmission control lever are in the mechanical park position. The transmission control lever can be positioned to mechanical park by rotating the control lever clockwise until it reaches its full clockwise position.
  1. Install the shift cable to the vehicle.
  2. Raise the vehicle.
    3. Fig 1: Shift Cable Black Shipping Tab
    GM105220Courtesy of GENERAL MOTORS CORP.
  3. Remove the black shipping tab from the transmission end of the shift cable and discard the tab.
  4. Install the ball stud on the transmission.
    5. Fig 2: Automatic Transmission Range Selector Cable
    GM105219Courtesy of GENERAL MOTORS CORP.
  5. Install the shift cable to the transmission bracket.
  6. Install the cable clip.
  7. Install the shift cable end to the transmission shift control lever by pushing the cable end onto the transmission shift control lever stud ball.
  8. Lock the primary lock.
  9. Lock the secondary lock.
    10. Fig 3: Left Front & Rear Shift Cable Clips
    GM105217Courtesy of GENERAL MOTORS CORP.
  10. Install the shift cable clips to the engine brackets.
  11. Lower the vehicle.
    12. Fig 4: Shift Cable-To-Steering Column Bracket Retaining Clip
    GM765121Courtesy of GENERAL MOTORS CORP.
  12. Install the rubber grommet to the floor panel.
    13. IMPORTANT: Ensure the shift lever is in the Park position.
  13. Install the shift cable to the steering column shift control.
  14. Install the clip securing the shift cable to the steering column bracket.
  15. Install the cable to the shift lever ball stud.
  16. Adjust the shift cable. Refer to Automatic Transmission Range Selector Cable Adjustment .
  17. Install the knee bolster bracket. Refer to Knee Bolster Bracket Replacement - Left in Instrument Panel, Gages and Console.
  18. Install the knee bolster trim panel. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals