LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Automatic Transmission - 4L80-E/4L85-E - Introduction & Repair Instructions) >> Repair Instructions >> Automatic Transmission Range Selector Cable Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Selector Cable Bracket And Cable
    GM777649Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission range selector cable bracket to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the transmission range selector cable bracket bolts (1).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Install the transmission range selector cable to the bracket (2) and the lever. Refer to Automatic Transmission Range Selector Cable Replacement .
  4. Lower the vehicle.
  5. Check the vehicle for proper operation. If adjustment of the cable is necessary, refer to Automatic Transmission Range Selector Cable Adjustment .
scientia non olet · About LEMON Manuals