Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Applying Sealant & Installing Oil Level Indicator Tube & Bolt

Courtesy of GENERAL MOTORS CORP.

Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent around the oil level indicator tube 13 mm (0.5 in) below the tube bead.
Install the oil level indicator tube into the engine block. Rotate the oil level indicator tube into position.

Fig 2: Upper & Lower Oil Level Indicator Tubes

Courtesy of GENERAL MOTORS CORP.

Apply sealer, GM P/N 12346004 (Canadian P/N 10953480) or equivalent, on the upper oil level indicator tube to the area where it fits into the lower half.
Install the oil level indicator tube upper half to the lower half.

Fig 3: Coolant Recovery Reservoir Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolt that holds the oil level indicator tube and the transmission fluid fill tube to the oil fill tube lower support.
Tighten: Tighten the oil fill level indicator tube and the transmission fluid fill tube to lower support bolt to 5 N.m (44 lb in).
Install the oil level indicator.
Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
Position the coolant recovery reservoir and install the bolt.