LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying J 41712
    GM348108Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
  2. Disconnect the engine oil pressure gage sensor electrical connector.
  3. Hold the engine oil pressure gage sensor fitting with a wrench.
  4. Remove the engine oil pressure gage sensor using J 41712  . See Special Tools .
    5. Fig 2: View Of Engine Oil Pressure Gage Sensor Fitting
    GM348110Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Note the alignment of the engine oil pressure gage sensor fitting prior to removal.
  5. Remove the engine oil pressure gage sensor fitting, if necessary.
scientia non olet · About LEMON Manuals