LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Crankshaft Position (CKP) Reluctor Ring Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Using J 5590 To Push The Crankshaft Position Sensor Reluctor Ring Onto The Crankshaft
    GM480576Courtesy of GENERAL MOTORS CORP.
    NOTE: Failure to properly align the crankshaft position sensor reluctor ring may result in component damage and effect OBD II system performance.
    IMPORTANT: The reluctor ring is shaped like a dish. The dish must face towards the engine front cover. Failure to do so will damage the front cover and the reluctor ring.
  1. Install the crankshaft position sensor reluctor ring.
    1. Align the keyway on the crankshaft position sensor reluctor ring with the crankshaft balancer key in the crankshaft.
    2. Use the J 5590  in order to push the crankshaft position sensor reluctor ring onto the crankshaft until completely seated against the crankshaft sprocket. See Special Tools .
  2. Install the engine front cover. Refer to Engine Front Cover Replacement .
scientia non olet · About LEMON Manuals