Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Remove the radiator. Refer to Radiator Replacement in Engine Cooling.
Remove the A/C condenser, if equipped. Refer to Condenser Replacement in Heating, Ventilation, and Air Conditioning.
Remove the valve lifter pushrod guide. Refer to Valve Lifter Replacement .
Remove the camshaft timing chain and sprockets. Refer to Timing Chain, Sprockets, and/or Tensioner Replacement .

Fig 1: View Of Balance Shaft Drive Gear

Courtesy of GENERAL MOTORS CORP.

Remove the balance shaft drive gear.

Fig 2: Locating Balance Shaft Driven Gear

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The balance shaft drive and balance shaft driven gears are serviced as a set. The set includes the balance shaft driven gear bolt.

Remove the balance shaft driven gear bolt from the balance shaft.
1. Use a wrench in order to secure the balance shaft.
  Place the wrench onto the balance shaft near to the balance shaft front bearing.
2. Remove the balance shaft bolt.
3. Remove the wrench from the balance shaft.
Remove the balance shaft driven gear from the balance shaft.

Fig 3: View of Balance Shaft Retainer & Bolts

Courtesy of GENERAL MOTORS CORP.

Remove the bolts and the balance shaft retainer.

Fig 4: Balance Shaft

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The balance shaft and the balance shaft front bearing are serviced only as a package. Do not remove the balance shaft front bearing from the balance shaft.

Use a soft-faced hammer in order to remove the balance shaft from the engine block.
Clean and inspect the balance shaft. Refer to Balance Shaft Cleaning and Inspection .