LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Knock Sensor (KS) Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.

The knock sensor (KS) is located at the top rear of the engine.

    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
    3. Fig 1: Locating Knock Sensor & Retaining Bolt
    GM679284Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the KS harness connector (3).
  4. Remove the KS bolt (1).
  5. Remove the KS (2).
scientia non olet · About LEMON Manuals