LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Ignition Coil(s) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: A replacement ignition coil kit comes with 2 screws in order to attach the ignition coil to the bracket.
  1. Install the ignition coil to the bracket with the 2 screws.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Ignition Coil, Bracket & Studs
    GM31466Courtesy of GENERAL MOTORS CORP.
  2. Install the ignition coil and the bracket to the intake manifold with studs.

    Tighten:  Tighten the studs to 11 N.m (97 lb in).

    3. Fig 2: View Of Accelerator Cable Bracket
    GM398027Courtesy of GENERAL MOTORS CORP.
  3. Install the accelerator control bracket.

    Tighten:  Tighten the accelerator control cable bracket nuts and studs to 12 N.m (106 lb in).

    4. Fig 3: View Of Ignition Coil Wire Harness
    GM387772Courtesy of GENERAL MOTORS CORP.
  4. Install the ignition coil wire.

    The wire must not touch anything like the dip stick. Rubbing will make a ground or short after time of use.

  5. Install the electrical connectors.
  6. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
scientia non olet · About LEMON Manuals