LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Heated Oxygen Sensor (HO2S) Replacement Bank 1 Sensor 1 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Refer to Vehicle Lifting Caution in Cautions and Notices.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Fig 1: Identifying O2 Sensor & Related Components
    GM715477Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Heated Oxygen and Oxygen Sensor Notice in Cautions and Notices.
  3. Disconnect the connector (1) for the HO2S.
  4. NOTE: Refer to Excessive Force and Oxygen Sensor Notice in Cautions and Notices.
  5. Remove the HO2S (2) using a J 39194-B  .