Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install the fuel fill pipe to the fuel fill hose.
- Align the fuel fill pipe to the fuel fill pipe housing.
Tighten: Tighten the fuel fill hose clamp to 2.75 N.m (24 lb in).
- Install the fuel filler tube ground strap bolt.
Tighten: Tighten the fuel filler tube ground strap bolt to 8 N.m (70 lb in).
- Lower the vehicle.
- Install the fuel fill pipe housing bolts and push-pin.
Tighten: Tighten the fuel fill pipe housing bolts to 6 N.m (53 lb in).
- Refill the fuel tank.
- Install the fuel filler cap.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.