LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of EVAP Pipe & Retaining Clips
    GM304560Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP pipe into the retaining clips (1).
    2. Fig 2: View Of Rear EVAP Purge Pipe
    GM569626Courtesy of GENERAL MOTORS CORP.
  2. Remove the cap from the rear EVAP pipe.
  3. Connect the rear EVAP purge pipe (3) to the chassis EVAP purge pipe (2).
  4. Install the EVAP pipe into the transfer case bracket clip, AWD drive only.
    5. Fig 3: View Of EVAP Pipe, Fuel Feed/Return Pipes & Engine Compartment Pipes
    GM583167Courtesy of GENERAL MOTORS CORP.
  5. Install the EVAP pipe into the transmission bracket clip.
  6. Install the EVAP pipe into the bellhousing stud clip (3).
  7. Lower the vehicle.
  8. Remove the cap from the engine compartment EVAP pipe.
  9. Connect the engine compartment EVAP pipe (1) to the chassis EVAP pipe (2).
  10. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
scientia non olet · About LEMON Manuals