Removal Procedure

WARNING: This page is about a different variant/trim than selected.

IMPORTANT: When replacing the evaporative emission (EVAP) pipe, always replace the pipe with original equipment or parts that meet the GM specifications for this part. The replacement pipe must have the same type of fittings as the original pipe in order to ensure the integrity of the connection.

Fig 1: View Of Fuel Tank & Straps

Courtesy of GENERAL MOTORS CORP.

Remove the fuel tank. Refer to Fuel Tank Replacement (Cutaway Van Side Tank) or Fuel Tank Replacement (Passenger/Cargo Van) or Fuel Tank Replacement (Cutaway Van Rear Tank) .

Fig 2: View Of EVAP Hoses/Pipes (Canister/Fuel Tank)

Courtesy of GENERAL MOTORS CORP.

Disconnect the rear EVAP vapor pipe (1) from the fuel sender (2), the fuel tank roll over valve (3), and the fuel tank clips (6).
Remove the EVAP vapor pipe from the fuel tank.
Cap the fuel sender EVAP pipe and the fuel tank roll over valve.