Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of EVAP Hoses/Pipes (Canister/Fuel Tank)

Courtesy of GENERAL MOTORS CORP.

Remove the caps from the fuel sender EVAP pipe and the fuel tank roll over valve.
Position the EVAP vapor pipe on the fuel tank.
Connect the EVAP vapor pipe (1) to the fuel sender (2), the fuel tank roll over valve (3), and the fuel tank clips (6).

Fig 2: View Of Fuel Tank & Straps

Courtesy of GENERAL MOTORS CORP.

Install the fuel tank. Refer to Fuel Tank Replacement (Cutaway Van Side Tank) or Fuel Tank Replacement (Passenger/Cargo Van) or Fuel Tank Replacement (Cutaway Van Rear Tank) .