LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement (Cutaway Van) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Fuel Feed Pipe At The Fuel Filter Inlet
    GM892640Courtesy of GENERAL MOTORS CORP.
  1. Connect the fuel tank EVAP pipe to the canister.
  2. Connect the chassis EVAP purge pipe to the EVAP canister.
  3. Connect the vent hose to the canister.
  4. Install the EVAP canister to the EVAP Canister bracket.
    5. NOTE: Refer to the Fastener Notice in Cautions and Notices.
  5. Install the EVAP canister bracket bolt.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  6. Lower the vehicle.
scientia non olet · About LEMON Manuals