LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Evaporative Emission (EVAP) Purge Pipe
    GM309184Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
  2. Disconnect the evaporative emission (EVAP) purge pipe.
    3. Fig 2: Identifying EVAP Canister Purge Valve Harness Connector
    GM309181Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the purge valve electrical connector.
    4. Fig 3: View Of Purge Solenoid Nuts
    GM309187Courtesy of GENERAL MOTORS CORP.
  4. Remove the purge valve mounting nuts.
  5. Remove the engine wiring harness bracket from the mounting stud.
    6. Fig 4: View Of Purge Solenoid
    GM309179Courtesy of GENERAL MOTORS CORP.
  6. Remove the purge valve from the intake manifold.
scientia non olet · About LEMON Manuals