LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Control System - 4.3L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Purge Solenoid
    GM309179Courtesy of GENERAL MOTORS CORP.
  1. Install the purge valve to the intake manifold.
  2. Install the engine wiring harness bracket to the mounting stud.
    3. Fig 2: View Of Purge Solenoid Nuts
    GM309187Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the purge valve mounting nuts.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

    4. Fig 3: Identifying EVAP Canister Purge Valve Harness Connector
    GM309181Courtesy of GENERAL MOTORS CORP.
  4. Connect the purge valve electrical connector.
    5. Fig 4: Evaporative Emission (EVAP) Purge Pipe
    GM309184Courtesy of GENERAL MOTORS CORP.
  5. Connect the EVAP purge pipe.
  6. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
scientia non olet · About LEMON Manuals