LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Passenger >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel (I/P) Carrier Replacement >> Installation Procedure

Installation Procedure

    Fig 1: I/P Carrier
    GM328139Courtesy of GENERAL MOTORS CORP.
  1. Install the I/P carrier to the vehicle.
  2. Install the wiring harness to the I/P carrier.
    3. Fig 2: Air Ducts To I/P Carrier Bolts
    GM301649Courtesy of GENERAL MOTORS CORP.
  3. Install the HVAC air distribution duct to the I/P carrier. Refer to Air Distributor Duct Replacement in Heating, Ventilation, and Air Conditioning.
  4. Carefully rotate the I/P carrier up to install the additional components.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the bolts that retain the I/P carrier to the vehicle.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  6. Install the instrument cluster wiring harness to the I/P carrier.
  7. Install the steering column wiring harness to the I/P carrier.
  8. Install the radio, the heater, and the A/C wiring harnesses to the I/P carrier.
  9. Install the heater and the A/C control. Refer to HVAC Control Assembly Replacement in Heating, Ventilation, and Air Conditioning.
  10. Install the I/P compartment, if equipped. Refer to Compartment Replacement - Instrument Panel (I/P) .
  11. Install the mounting bracket and radio, if equipped. Refer to Radio Replacement in Entertainment.
  12. Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
  13. Install the I/P upper trim pad. Refer to Trim Pad Replacement - Instrument Panel (I/P) Upper .
  14. Install the passenger side SIR module. Refer to Inflatable Restraint Instrument Panel Module Replacement in SIR.
  15. Install the right hinge pillar trim panel. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
  16. Install the left hinge pillar trim panel. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
  17. Install the instrument cluster assembly. Refer to Instrument Panel Cluster (IPC) Replacement .
  18. Install the I/P cluster trim plate bezel. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster .
  19. Install the steering column. Refer to Steering Column Replacement in Steering Wheel and Column.
  20. Install the left knee bolster. Refer to Knee Bolster Replacement - Left .
  21. Install the left knee bolster bracket. Refer to Knee Bolster Bracket Replacement - Left .
  22. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 and SIR Disabling and Enabling Zone 5 in SIR.
  23. Install the right knee bolster bracket. Refer to Knee Bolster Bracket Replacement - Right .
  24. Install the BCM. Refer to Body Control Module Replacement in Computer/Integrating Systems.
  25. Install the right knee bolster. Refer to Knee Bolster Replacement - Right .
  26. Connect the battery negative cable(s). Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About LEMON Manuals