LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Wheel Hub, Bearing, Knuckle, and Seal Replacement >> Disassembly Procedure

Disassembly Procedure

    Fig 1: Drive Axle & Inner Snap Ring
    GM1241983Courtesy of GENERAL MOTORS CORP.
  1. Remove the drive axle from the front wheel hub. Refer to Strut Assembly Replacement .
  2. Remove the inner snap ring.
    3. Fig 2: Wheel Hub & Components
    GM1241984Courtesy of GENERAL MOTORS CORP.
  3. Remove the wheel hub with the J 37105-1  , the J 37105-3  , the 500-20  , and the J 37105-2  . See Special Tools .
    4. Fig 3: Disc Brake Splash & Outer Snap Ring
    GM1241985Courtesy of GENERAL MOTORS CORP.
  4. Remove the disc brake splash. Refer to Disc Brake Splash Shield Replacement - Front in Disc Brakes.
  5. Remove the outer snap ring.
    6. Fig 4: Wheel Bearing & Components
    GM1241986Courtesy of GENERAL MOTORS CORP.
  6. Remove the wheel bearing with the J 37105-1  , the J 37105-2  , the 500-20  , and the J 36661-2  . See Special Tools .
  7. Clean the bore of the knuckle.
scientia non olet · About LEMON Manuals