LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front Suspension System >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: U-Clamp Bolts & Stabilizer Bar
    GM1241980Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the U-clamp bolts to the stabilizer bar.

    Tighten:  Tighten the U-clamp bolts to the stabilizer bar to 25 N.m (18 lb ft).

  2. Remove the crossmember assembly.
scientia non olet · About LEMON Manuals