LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Wheel Nut & Retaining Clip
    GM1248385Courtesy of GENERAL MOTORS CORP.
  1. Clip the contact ring on the steering wheel, if necessary.
    2. IMPORTANT: In order to install the steering wheel correctly, match-mark the steering column shaft to the steering wheel.
  2. Align the match marks on the steering wheel and the steering column shaft. Turn the signal-canceling cam on the wheel to the left.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the retaining clip and the steering wheel nut.

    Tighten:  Tighten the steering wheel nut to 38 N.m (28 lb ft).

  4. Bend the tabs to secure the retaining clip.
  5. Install the SIR module. Refer to Disabling the SIR System in SIR.
  6. Connect the negative battery cable.
scientia non olet · About LEMON Manuals