Conditions for Setting the DTC
The voltage supplied from the battery is over 16.5 volts.
DTC 023
| Step | Action | Yes | No |
|---|---|---|---|
|
CAUTION:
Refer to SDM Voltage After Ignition Is Turned OFF Caution
in Cautions and Notices.
CAUTION:
Refer to Sensing and Diagnostic Module Handling Caution
in Cautions and Notices.
|
|||
| 1 | Perform the Diagnostic System Check - SIR. Is the Diagnostic System Check - SIR complete? |
Go to Step 2 | Go to Diagnostic System Check - SIR |
| 2 | Inspect the vehicle's charging system. Refer to Charging System Test
in Engine Electrical. Is the charging system OK? |
Go to Step 4 | Go to Step 3 |
| 3 | Repair the charging system. Is the repair complete? |
Go to Diagnostic System Check - SIR | - |
| 4 |
|
Go to Diagnostic System Check - SIR | - |