Case Porosity Repair
WARNING: This page is about a different variant/trim than selected.
- Determine the leak area. Refer to Automatic Transmission Fluid Leaks .
- Clean the leak area with the solvent. Air dry.
- Mix a sufficient amount of epoxy cement following the manufacturer's recommendations.
- While the transaxle case is hot, apply epoxy cement with a clean, dry soldering acid brush.
- Allow the epoxy cement to dry for 3 hours before starting the engine.
CAUTION:
Refer to Eye Protection Caution
in Cautions and Notices.
CAUTION:
The epoxy adhesive may cause skin irritations and eye damage. Read and follow all of the information on the container label as provided by the manufacturer.