LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions >> Transmission Cooler Pipes and Hoses Replacement (Inlet) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Radiator Threaded Connector & Fluid Cooler Hoses
    GM1245838Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Vehicle Lifting and Jacking Notice in Cautions and Notices.
  1. Raise and support the vehicle.
  2. Drain the transaxle fluid.
  3. Remove the clip from the radiator threaded connector, then disconnect the fluid cooler hoses.
    4. Fig 2: Removing Fluid Cooler Inlet Pipe, Bolt & Transaxle
    GM1245839Courtesy of GENERAL MOTORS CORP.
  4. Remove the fluid cooler inlet pipe bolt from the transaxle.
  5. Remove the inlet pipe fitting nut from the transaxle.
  6. Remove the fluid cooler inlet pipe and hoses.
scientia non olet · About LEMON Manuals