LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions >> Shift Control Cable Replacement - Floor Shift >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Control Cable Adjusting Nut
    GM1245812Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the floor console. Refer to Console Replacement - Front Floor in Instrument Panel, Gages, and Console.
  3. Remove the cable adjusting nut.
  4. Disconnect the shift control cable from the shift control lever assembly.
    5. Fig 2: Shift Control Cable & PNP Switch Lever
    GM1245820Courtesy of GENERAL MOTORS CORP.
  5. Remove the shift control cable retaining E-ring.
  6. Disconnect the shift control cable from the park/neutral position (PNP) switch.
    7. Fig 3: Shift Control Cable, Bracket & Fastener
    GM1245826Courtesy of GENERAL MOTORS CORP.
  7. Remove the E-ring from the shift control cable bracket and disconnect the shift control cable.
  8. Disconnect the shift control cable from the shift control cable fastener.
  9. Remove the shift control cable from the vehicle.
scientia non olet · About LEMON Manuals